商品描述：
LZ-25商用自流平
產品介紹：
LZ-25商用自流平，采用特種水泥、精細骨料、聚合物噴霧干粉樹脂及其它水泥添加劑等原料精制而成，是具有高流動性、高塑性的自流平地基材料，為鋪設各類彈性地板、地毯、木地板等地面材料提供平整、完好、堅實的理想基層，屬無毒、無害、綠色環保產品。適用于家庭、辦公室、小型商業設施等抗壓強度要求不高的場所。
PRODUCT DEscriptION
LZ-25 commercial self-leveling compound is combined of special cement, selected aggregate, polymer spray dry powder resin and other cement additives, which is featured as high flowability and high plasticity and environmentally friendly. It can provide smooth, and solid foundation for floor such as elastic floor, carpets and composite floor, etc. And also it has been widely applied in commercial area like office, home and other area.
特點：
快速自動找平地面，快凝，低收縮；
可自由控制施工厚度，施工厚度為3-5mm；
有優良的抗壓、抗折強度；
環保、防潮、速干。
CHARACTERISTIC:
Rapid hardening, self-smoothing, and low shrinkage.
The thickness can be controlled freely from 3mm to 5mm.
High compressive and flexural strength.
Environmentally friendly, damp-proof and quick-dry.
基層要求：
①基層須具備室內溫度在5-30℃，地面基層的含水率＜千分之三；
②基層必須干燥、堅實、可承重、無妨礙粘結雜物，表面平整；
③具有良好的抗壓強度；
④為保證自流平流動性和附著力，建議使用合適的多功能水性界面劑。
REQUIREMENT:
①The indoor allowed temperature should be from 5 to 30 degree Celsius.
②The substrate should be clean, flat, dry and strong without any loose part.
③High compressive strength.
④Suitable primer is highly recommended in order to ensure the self-leveling surface strength and adhesion.
技術參數：
|
LZ-25 |
|
|
存儲期 |
6個月 |
|
混合比 |
1:6L/水 |
|
施工面積 |
1.4kg/mm |
|
可施工時間 |
30min |
|
可行人時間 |
3-4h |
|
可鋪設地板所需時間 |
3d |
|
抗壓強度 |
20-28mpa |
|
抗折強度 |
6 |
TECHNICAL
|
LZ-25 |
|
|
Warranty |
6 months |
|
Mixing rate |
1:6L/水 |
|
Spreading area |
1.4kg/mm |
|
Working time |
30min |
|
Workable time |
3-4h |
|
Floor covering |
3d |
|
Compressive time |
20-28mpa |
|
Flexural strength |
6 |
施工方法：
①基層清理干凈后，先選用合適的水性界面劑涂刷基層，當界面劑已被基層吸收，處于全干狀態時（施工后1-3小時），開始自流平施工。
②在攪拌容器中加入6L清水，然后慢慢加入一包25kg的自流平，用攪拌機攪拌3-5分鐘后，將混合料倒出，均勻地鋪開，用專用的齒口刮板控制厚度，混合料必須在20分鐘內用完，剛施工好的自流平要防止受陽光直射和強風吹拂。
③在自流平初凝前，用消泡滾筒滾軋地面以排除混合時帶入的空氣。
ConSTRUCTION STEPS:
①The suitable primer will be roller painted firstly after cleaning up the the basic floor. And the self-leveling compound will be applied after the primer absorbed completely within 1-3 hours.
②The 25kg compound will be mixed slowly by 6L water in container. And poured out the mixer after stirring 3-5minutes by blender mixer. This job should be finished within 20mins by special scraper which can control the thickness around 1-3mm. After done, the finished job should be protected from sun and strong wind.
③ The use of a spiked roller may aid the final leveling of the material and spiked roller should be used within the flow time of the product.
注意事項
由于本品含水泥，會與水反應產生強堿性，避免與皮膚、眼睛接觸。一旦接觸，立即用水沖洗；如果皮膚或眼睛受到傷害，立即就醫。本產品完全硬化后不會產生對身體、環境有影響的物質。
Attention:
The product is considered non-hazardous in normal usage. However it contains Portland cement and reacts alkaline which may cause some skin irritation after prolonged contact. Avoid contact with eyes or skin. In case of contact with eyes, rinse for several minutes under running water, and seek medical advice. Physiologically and ecologically safe when in the cured state.
包裝與儲存
25kg復合紙袋包裝。本品須存放于室內，注意防潮、防止冰凍、曝曬。
托盤上堆放不超過8層，保質期為6個月。
PACKAGE AND STORAGE:
25KG multi-layer paper bag. The warranty is about 6 months. The product shall be stored indoor, protected from moisture, kept away from direct sunlight and source of heat. Stacked on pallets less than 8 layers.